Engineering, 21.11.2019 06:31, Isabella1319
Consider a stainless steel material with a brinnel hardness of 270, that is turned on a lathe. the undeformed chip thickness is 0.25 mm, and the cutting speed is 0.6 m/s. the chip is continuous and a 1- m-long section weighs 5.7 g. the chip width is the same as the workpiece width and equals 1.5 mm. calculate the cutting ratio. assume the density of the stainless steel is 8027 kg/m^3.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Do you know the correct answer?
Consider a stainless steel material with a brinnel hardness of 270, that is turned on a lathe. the u...
Questions in other subjects:
Business, 27.07.2019 17:10
