Engineering, 21.11.2019 01:31, 1991987

The statement that is correct about the relation between the velocity and thermal boundary layers for flow over a flat plate is a. if the velocity boundary layer is turbulent, so is the thermal boundary layer. b. if the velocity boundary layer is turbulent, then the thermal boundary layer is much thinner than the velocity boundary layer. c. there can be a thermal boundary layer without a velocity boundary layer if the flow is laminar. d. the velocity boundary layer grows with distance along the plate, but the thermal boundary layer is constant with distance.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

Engineering, 04.07.2019 19:10, pjgolden04

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

continue

Engineering, 06.07.2019 03:20, demotte79991

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

continue

Do you know the correct answer?

The statement that is correct about the relation between the velocity and thermal boundary layers fo...