Engineering
Engineering, 19.11.2019 07:31, jstringe424

If an organization must evaluate the following three information assets for risk management, which vulnerability should be evaluated first for additional safety controls? which should be evaluated last? ·switch l47 connects a network to the internet. it has two vulnerabilities: it is susceptible to hardware failure at a likelihood of 0.2, and it is subject to an snmp buffer overflow attack at a likelihood of 0.1. this switch has an impact rating of 90 and has no current controls in place. you are 75% certain of the assumptions and data. ·server websrv6 hosts a company web site and performs e-commerce transactions. it has a web server version that can be attacked by sending it invalid unicode values. the likelihood of that attack is estimated at 0.1. the server has been assigned an impact value of 100, and a control has been implanted that reduces the impact of vulnerability by 75%. you are 80% certain of the assumptions and data. ·operators use an mgmt45 control console to monitor operations in the server room. it has no passwords and is susceptible to unlogged misuse by the operators. estimates show the likelihood of the misuse is 0.1. there are no controls in place on this asset; it has an impact rating of 5. you are 90% certain of the assumptions and data.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 19:10, kimmy6973
What is creep? what is stress relaxation?
Answers: 1
image
Engineering, 04.07.2019 19:10, nayi2002
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
image
Engineering, 04.07.2019 19:20, mads000
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
Do you know the correct answer?
If an organization must evaluate the following three information assets for risk management, which v...

Questions in other subjects: