Engineering
Engineering, 19.11.2019 04:31, ashleymunoz928

An angle bracket is bent in a v-bending operation on a press brake from a flat blank that is 4.0 in long by 1.5 in wide by 5/32 in thick. the 90bend is made in the middle of the 4-in length, so that the bend axis is 1.5 inlong.

(a) determine the dimensions of the two equal sides that will result after the bend, if the bend radius = 3/16 in. the sides should be measured to the beginning of the bend radius.

(b) also, determine the length of the two equal sides assuming the sheet metal did not stretch.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
image
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
image
Engineering, 04.07.2019 19:20, zoebtharpe
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection
Answers: 1
image
Engineering, 06.07.2019 03:10, serenad2
Different between boring and turning?
Answers: 1
Do you know the correct answer?
An angle bracket is bent in a v-bending operation on a press brake from a flat blank that is 4.0 in...

Questions in other subjects:

Konu
Mathematics, 26.01.2021 18:20
Konu
Health, 26.01.2021 18:20