Engineering, 19.11.2019 01:31, prettygirl2204

Apump is to be used to fill two storage tanks. the pump is manaually started by the operator from the start/stop section. when the first tank is full, the control logic must be able to automaticly stop the flow to the first tank and direct the flow to the second tank through the use of sensors and electric solenoid valves. when the second tank is full, the pump must be shut down automatically. indicator lamps are to be included to signal when each tank is full. a. draw a sketch of the process b. prepare a typical plc program for this control process

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Engineering, 04.07.2019 18:20, cdyshaylia55

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

continue

Engineering, 04.07.2019 19:10, kayleeemerson77

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

continue

Do you know the correct answer?

Apump is to be used to fill two storage tanks. the pump is manaually started by the operator from th...