Engineering, 18.11.2019 22:31, luje

You have designed a little wheeled mobile robot and would like to compute the power drawn by themotors when the robot moves on different surfaces.
attaching wires to the robot will impede itsmotion so you want to determine a way to measure current going to the motors without wires. youare able to find the no load speed of the motor (920 rpm) and the stall torque (35 g-cm) whenoperated at 3v.

a. you run the robot with its wheels spinning in air and find the current required to overcomefriction in the motor and robot (inl) is 40 ma. what is the torque required to overcome thisfriction?

b. you are able to measure the wheel speed of the robot by calculating the robots speed andmaking sure that the wheels do not slip. if the wheels are rotating at 400 rpm at the same 3v, what is the motor current draw?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, siri5645

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Do you know the correct answer?

You have designed a little wheeled mobile robot and would like to compute the power drawn by themoto...