Engineering, 18.11.2019 18:31, haylie1456

Prob: 2 a cylindrical specimen of aluminum having a diameter of 0.505 in. (12.8 mm) and a gauge length of 2.000 in. (50.800 mm) is pulled in tension. use the load–elongation characteristics tabulated below and (a) plot the data as engineering stress versus engineering strain. (b) compute the modulus of elasticity. (c) determine the yield strength at a strain offset of 0.002. (d) determine the tensile strength of this alloy. (e) what is the (approximate) ductility, in percent elongation? (f) populate that data with corresponding true stress and strain values (g) compute the strain hardening exponent by using the equation

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Do you know the correct answer?

Prob: 2 a cylindrical specimen of aluminum having a diameter of 0.505 in. (12.8 mm) and a gauge len...