Engineering, 16.11.2019 02:31, Heartlesskiidkii
Consider a single-family, detached, single-story house located in suburban long island. the location has a design outdoor temperature of 13°f and the indoor temperature is typically maintained at 70°f during the heating season. the house is built on a slab-on-grade foundation and has no garage. the house has the following characteristics:
len width wall height perimeter floor area gross wall area net wall area window area door area (openings roof area gross volume (living area construction qualit 56 ft 32 ft 8 ft 176 ft 1792 1408 1114 252 42 2060 14,366 ft tight general foundationslab on grade with 8-in. foundation walls with and vertical board insulation on outside of foundation walls r-value of insulation walls windows doors roof/ceiling (based on ceiling area 5.4 (hr ft f)ybtu 0.084 btu/(hr ftf 0.420 btu/( hr fff 0.350 btu/( hr frof 0.030 btu/( hr ftzof u-values
using the information presented above, perform the following calculations to determine the design heating load for the house.
(a) what is the design heat loss due to transmission heat transfer through the combined above-grade, building envelope (walls, windows, door, and ceiling)?
(b) what is the design heat loss due to heat transfer through the slab-on-grade floor?
(c) the infiltration leakage area has been determined to be 91.6 in^2 (590 cm^2). if the design winter wind velocity is 15 mi/h (6.7 m/s), what is the volumetric flow rate of infiltration air?
Answers: 3
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
Consider a single-family, detached, single-story house located in suburban long island. the location...
English, 21.08.2020 08:01
Chemistry, 21.08.2020 08:01
Mathematics, 21.08.2020 08:01
Mathematics, 21.08.2020 08:01
World Languages, 21.08.2020 08:01
Chemistry, 21.08.2020 08:01