Engineering, 14.11.2019 07:31, oofdiegoofdie5562

Aboost converter based power factor correction circuit needs to operate with universal input voltage, i. e the input voltage can be either 120v (rms)+/- 10% at 60 hz or 240 v(rms) +/- 10% at 50 hz. the output voltage is regulated at 400 v dc and the maximum (average) output power is 1kw.

(a) calculate the value of inductance needed to keep its peak-peak ripple current to be less than 10% of the peak fundamental frequency line current at the maximum input voltage and full load condition.

(b) calculate the value of output capacitance needed to keep the peak-peak ripple (at twice the line frequency) to be less than 10% of the nominal output voltage at any operating condition.

(c) calculate the maximum rms ripple current in the output capacitor (neglect switching frequency ripple).

(d) draw over a complete fundamental period corresponding to 240v (rms), 50 hz input.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Do you know the correct answer?

Aboost converter based power factor correction circuit needs to operate with universal input voltage...