Engineering
Engineering, 14.11.2019 04:31, madisonwr

Aprojectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameter pipe. water flows through the pipe. at the upstream location 1, the velocity is uniform and equal to 2 m/s. the water exits to the atmosphere where the pressure is 100 kpa. find the force required to hold the object in place. be sure to state your assumptions. be explicit in defining your control volume - remember that the cv must be defined so that an external force can be defined. (see additional documentation regarding the choice of a control volume. for extra credit, show that the analyses from the two cv's are consistent with each other; i. e., show that the force on the projectile is the integrated pressure over its surface, as would be expected.)

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 03:10, lauriepdx17
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Do you know the correct answer?
Aprojectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameter pip...

Questions in other subjects:

Konu
Mathematics, 27.02.2021 01:00
Konu
History, 27.02.2021 01:00