Engineering
Engineering, 14.11.2019 03:31, hannahkharel2

The fatigue data for a ductile cast iron are given as follows: stress amplitude [mpa (ksi)] cycles to failure 248 (36.0) 1 × 105 236 (34.2) 3 × 105 224 (32.5) 1 × 106 213 (30.9) 3 × 106 201 (29.1) 1 × 107 193 (28.0) 3 × 107 193 (28.0) 1 × 108 193 (28.0) 3 × 108
(a) make an s–n plot (stress amplitude versus logarithm cycles to failure) using these data.
(b) what is the fatigue limit for this alloy?
(c) determine fatigue lifetimes at stress amplitudes of 230 mpa (33,500 psi) and 175 mpa (25,000 psi).
(d) estimate fatigue strengths at 2 × 105 and 6 × 106 cycles.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Do you know the correct answer?
The fatigue data for a ductile cast iron are given as follows: stress amplitude [mpa (ksi)] cycles...

Questions in other subjects:

Konu
Mathematics, 21.10.2020 22:01
Konu
Computers and Technology, 21.10.2020 22:01