Engineering
Engineering, 14.11.2019 02:31, zitterkoph

Circle the correct answer or fill in the blank a) the decimal equivalent of the binary number 1110 1101 is b) a(n) is a transistor that has terminals called gate, source, and drain. this type of transistor is common in integrated circuits such as microprocessors and memory. c) a dram memory cell is made with one transistor and what other basic device? d) dram and sram are e) f) . this means that they lose their data when the power is turned off. memory is the most common type of eeprom. instead of microprocessors are used in embedded applications. they are intended for special purpose rather than general purpose use. g) a dram's logic state will fade away with the passage of time. that's why these devices need h) i) modern microprocessors use buffers are used to make buses, such as the data bus and the address bus. memory to speed access to instructions and data. this type of memory is much faster than main memory and frequently resides on the microprocessor chip j) a(n) is an adjunct to the microprocessor. its chief task is to do floating point math.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, Mimidj9279
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
image
Engineering, 04.07.2019 19:10, alex6toes
What are the major differences between injection molding and extrusion?
Answers: 2
Do you know the correct answer?
Circle the correct answer or fill in the blank a) the decimal equivalent of the binary number 1110 1...

Questions in other subjects:

Konu
Mathematics, 17.05.2021 21:00
Konu
Mathematics, 17.05.2021 21:00