Engineering, 13.11.2019 22:31, mackaylabarnes22

Determine the required height h of the roller coaster so that when it is essentially at rest at the crest of the hill a it will reach a speed of 100 km/h when it comes to the bottom b. also, what should be the minimum radius of curvature rho for the track at b so that the passengers do not experience a normal force greater than 4mg=(39.24m)n? neglect the size of the car and passenger.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Engineering, 04.07.2019 19:10, Calliedevore

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Do you know the correct answer?

Determine the required height h of the roller coaster so that when it is essentially at rest at the...