Engineering, 13.11.2019 19:31, Kykebailey2356

Asteam turbine operating with a steady mass flow rate of 3.00 kg/s produces power output of 3.0 mw the inlet conditions are p1 = 60 bar and ti = 600°c, and outlet conditions are p2 0.20 bar and x2 0.97. the heat transfer from the turbine occurs at a boundary temperature tb = 350 k. neglect kinetic and potential energy changes. assume that the given pressures are absolute
(a) on a t-s diagram, indicate the process including lines of constant pressure.
(b) determine the rate of heat transfer to the surroundings, in kw. (c) determine the entropy generation rate, in kw/k

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:20, anggar20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

continue

Do you know the correct answer?

Asteam turbine operating with a steady mass flow rate of 3.00 kg/s produces power output of 3.0 mw t...