Engineering, 11.11.2019 23:31, madisonmcelvany2404

One hundred electrical components, each dissipating 25 w, are attached to one surface of a square (0.2 m 0.2 m) copper plate, and all the dissipated energy is transferred to water in parallel flow over the opposite surface. a protuberance at the leading edge of the plate acts to trip the boundary layer, and the plate itself may be assumed to be isothermal. the water velocity and temperature are u 2 m/s and t 17 c, and the water’s thermophysical properties may be approximated as 0.96 106 m2 /s, k 0.620 w/m k, and pr 5.2. ch007.qxd 4/14/11 8: 23 pm page 471

(a) what is the temperature of the copper plate?

(b) if each component has a plate contact surface area of 1 cm2 and the corresponding contact resistance is 2 104 m2 k/w, what is the component temperature? neglect the temperature variation across the thickness of the copper plate.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Do you know the correct answer?

One hundred electrical components, each dissipating 25 w, are attached to one surface of a square (0...