Engineering, 10.11.2019 06:31, cbrewer37
Write an arduino sketch that programs your multi-colored led so that the red and green leds are on for 500 ms, then only the blue led is on for 500 ms, then finally only the green led is on for 500 ms. this pattern of leds flashing should continue forever. circuit hint: • you can wire up leds from digital pins 10, 11, and 12 of your arduino with a 330 ohm resistor for each led. make sure that all the grounds are connected together to arduino gnd.
Answers: 1
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
Engineering, 04.07.2019 19:10, nbunny7208
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
Write an arduino sketch that programs your multi-colored led so that the red and green leds are on f...
Mathematics, 02.03.2021 14:00
Mathematics, 02.03.2021 14:00
Mathematics, 02.03.2021 14:00
History, 02.03.2021 14:00
Mathematics, 02.03.2021 14:00
Computers and Technology, 02.03.2021 14:00