Engineering
Engineering, 09.11.2019 07:31, drakkeo

Cyanide (cn-) is a metabolic poison that inhibits the activity of complex iv. reduced complex iv must be able to bind to oxygen (o2) in a particular location on the enzyme called its "active site," in order to catalyze the reduction of o2. but cyanide binds in the same location, preventing complex iv from binding and reducing oxygen. for this reason, it’s called a "competitive inhibitor" of complex iv. which of the following would you expect to see in the mitochondria of cells exposed to cyanide, relative to cells that are not exposed to cyanide? (select two answers)decreased levels of reduced complex ivincreased levels of reduced complex i increased concentration of nad+ decreased atp productionincreased atp production

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 08:10, doggo242
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Do you know the correct answer?
Cyanide (cn-) is a metabolic poison that inhibits the activity of complex iv. reduced complex iv mus...

Questions in other subjects:

Konu
Biology, 26.02.2021 20:50
Konu
Mathematics, 26.02.2021 21:00