Engineering
Engineering, 08.11.2019 05:31, lilyclairehutson

Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25
o
c by absorbing heat from geothermal water that enters the evaporator at 60
o
c at a rate of 0.065 kg/s and leaves at 40
o
c. refrigerant enters the evaporator at 12
o
c with a quality of 15% and leaves at the same pressure as saturated vapor.

if the compressor consumes 1.6 kw of power, determine

(a) the mass flow rate of the refrigerant,
(b) the rate of heat supply,
(c) the cop,
(d) the minimum power input to the compressor for the same rate of heat supply

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
image
Engineering, 04.07.2019 18:20, annette211pdd8v9
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
image
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
Do you know the correct answer?
Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25
o
c...

Questions in other subjects:

Konu
Mathematics, 01.07.2019 04:00