Engineering, 08.11.2019 04:31, jeffylovesgreenbeans

Ahydraulic press is powered by a remote high-pressure pump. the gage pressure at the pump is 20 mpa, and the pressure required to operate the press is 19mpa (gage) at a flow rate of 0.032 m3/min. the press and pump are to be connected by 100 m of drawn stainless steel tubing. the fluid properties are as follows: µ=50 cp, sg = 0.90. what is the minimum tubing diameter that can be used? what commercial steel pipe nominal size is suitable for this purpose if schedule number is 80?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Do you know the correct answer?

Ahydraulic press is powered by a remote high-pressure pump. the gage pressure at the pump is 20 mpa,...