Engineering, 07.11.2019 06:31, DavidYSD46481

1. if you look at a reaction equation for a fischer esterification reaction, you cannot tell where the oxygen comes from (acid or alcohol). knowing the mechanism of this reaction, devise an experiment using o18, to prove unequivocally where the oxygen comes from. 2 the fischer esterification is highly reversible and the products are only, slightly favored. state two procedures you did to drive the reaction to the ester. 3. a student forgot to remove their silica gel beads before distillation of ester product. after distillation, his product was cloudy, indicating it was wet. why

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, nandalabella06

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Do you know the correct answer?

1. if you look at a reaction equation for a fischer esterification reaction, you cannot tell where t...