Engineering
Engineering, 05.11.2019 03:31, samv6390

Consider the evaporator section of an air-conditioning system (note: the evaporator may be considered as a shell and tube heat exchanger with refrigerant flowing through the tube and air flowing through the shell). air enters the evaporator at 32◦c and 1 bar with a volumetric flow rate of 50 m3/min and exits at 22◦c and 0.95 bar. refrigerant 134a at 5 bar with a quality of 20% enters the evaporator and leaves at 20◦c at the same pressure. assume steady state operation, negligible heat transfer at the outer surface of the heat exchanger, and negligible kinetic and potential energy effects. also, assume the air behaves as an ideal gas with constant specific heats. determine

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Do you know the correct answer?
Consider the evaporator section of an air-conditioning system (note: the evaporator may be consider...

Questions in other subjects:

Konu
English, 30.12.2020 09:40
Konu
Arts, 30.12.2020 09:40