Engineering, 02.11.2019 06:31, jayv1999

Ajet boat takes in water at a constant rate q through the side vents and ejects water at a high jet speed, vj, at the rear. vj is measured relative to the speed of the boat. a variable area exit orifice controls the jet speed. the drag force on the boat is given by d = kv2, where k is a constant and v is the boat speed (measured by a stationary observer). assume steady, incompressible flow that is uniform across inlets and outlets. v = 12 m/s when vj = 30 m/s. a.find an expression for v in terms ofvj. b. what vj is needed to produce a boat speed of 22 m/s?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, Doogsterr

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

continue

Engineering, 04.07.2019 19:10, ultimateapes

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Do you know the correct answer?

Ajet boat takes in water at a constant rate q through the side vents and ejects water at a high jet...