Engineering, 01.11.2019 04:31, vanessapineda11

The matlab code below creates a sinusoid and plays it as a single tone: tt e: (1/4000) : 9; xx cos (2pi13000tt soundsc(xx, fsamp) + 0.7pi); although the sinusoid was not written have a frequency of 5700 hz, it is possible to play out the vector xx so that it sounds like a 5700 hz tone. determine the value of fsamp that should be used in the soundsc) command to have the sound be a 5700 hz tone. hint: analyze the code. don't run it.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Do you know the correct answer?

The matlab code below creates a sinusoid and plays it as a single tone: tt e: (1/4000) : 9; xx co...