Engineering
Engineering, 31.10.2019 00:31, jocelyntucker

Afuel cell is an electrochemical device that reacts hydrogen with oxygen from the air to produce water and dc electricity. a proposed application is replacement of the gasoline-fueled internal combustion engine in an automobile with a 100 kw fuel cell. you are on a summer internship with a gas supplier planning to transport hydrogen to service stations for use in cars powered by fuel cells. the hydrogen is to be transported in tube trailers, each of which has 10 tubes of length 10.5 m and diameter 0.56 m. hydrogen in the tubes at 2600 psig and an average temperature of 298 k is discharged at service stations to a final pressure of 55 psig. refueling each fuel-cell-powered automobile is estimated to require 4.0 kg of hydrogen. a) you and your office-mate—an intern from a different university—have been asked to estimate the number of automobiles that can be refueled by one tube-trailer load of hydrogen. he does a very quick calculation and comes up with a value of 95 cars. speculate how he did it and provide support for your speculation. what was his mistake? b) do the calculation using the law of corresponding states instead. (remember that for hydrogen and helium adjusted critical temperature and pressure values should be used)

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
image
Engineering, 04.07.2019 18:10, niicoleassssssf
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Do you know the correct answer?
Afuel cell is an electrochemical device that reacts hydrogen with oxygen from the air to produce wat...

Questions in other subjects: