Engineering, 30.10.2019 20:31, write2lakenor7awj

Q2. (20 points). a cylindrical rod 100 mm long and having a diameter of 10.0 mm is to be deformed using a tensile load of 27,500 n. it must not experience either plastic deformation or a diameter reduction of more than 7.5×10-3 mm. of the materials listed as follows, which are possible candidates? justify your choice(s). material modulus of elasticity(gpa) yield strength (mpa) poisson's ratio aluminum alloy 70 200 0.33 brass alloy 101 300 0.34 steel alloy 207 400 0.30 titanium alloy 107 650 0.34

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Do you know the correct answer?

Q2. (20 points). a cylindrical rod 100 mm long and having a diameter of 10.0 mm is to be deformed us...