Engineering
Engineering, 28.10.2019 22:31, gedntrxAa

Circular copper rods of diameter d=1mm and length l=25mm areused to enhance heat transfer from a surface that is maintained atts,1=100 deg. c. one end of the rod is attached tothis surface (at x=o), hile the other end (at x=25mm) is joined toa second surface that is maintained at ts,2=0deg. c. air flowing between the surfaces (and over the rods)is also at a temperature t? = 0 deg. c, and has a convectioncoefficient of h=100 w/m2kelvin.

a. what is the rate of heat transfer by convection from a singlecopper rod to air?
b. what is the total rate of heat transfer from a 1 m x 1 m section of the surface at 100 deg. c, if a bundle of the rods is installed on 4-mm centers?

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Do you know the correct answer?
Circular copper rods of diameter d=1mm and length l=25mm areused to enhance heat transfer from a sur...

Questions in other subjects: