Engineering
Engineering, 25.10.2019 20:43, GILLIG6003

How many vms can you put on a host? your boss has received the following quote for a potential virtualization server: server dell r630processor dual xeon e5-2954memory 24 x 32gb rdimmnetwork dual intel x520dp 10gb sfp+total cost $24,198.13this server will be attached to an existing iscsi san in your network. your boss wants to use this hardware to host several vms, each with 2 vcpus and 4gb ram. note: performance monitoring for the vms show an average of < 10% cpu utilization and 3gb ram utilizationyour boss wants you to research and discuss how many of these vms can be run on this hardware. why? what are the limiting factors? if faster cpus, more ram, or other components are added to this host, can you put more vms on this host?

is there a maximum number of vms you can put on this server? is there a maximum number that you should be put on this server?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, margaret1758
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 18:10, selenamr
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
Do you know the correct answer?
How many vms can you put on a host? your boss has received the following quote for a potential virtu...

Questions in other subjects:

Konu
Chemistry, 23.10.2019 00:20
Konu
Mathematics, 23.10.2019 00:20