Engineering, 25.10.2019 02:43, lbab

Acylindrical fuel rod (k 5 30 w/m∙k) of 2 cm in diameter is encased in a concentric tube and cooled by water. the fuel rod generates heat uniformly at a rate of 100 mw/m3 , and the average temperature of the cooling water is 75°c with a convection heat transfer coefficient of 2500 w/m2 ∙k. the operating pressure of the cooling water is such that the surface temperature of the fuel rod must be kept below 200°c to avoid the cooling water from reaching the critical heat flux (chf). the critical heat flux is a thermal limit at which a boiling crisis can occur that cause overheating on the fuel rod surface and lead to damage. determine the variation of cen98187_ch02_p067-141.indd 133 14/02/14 3: 01 pm 134 heat conduction equation temperature in the fuel rod and the temperature of the fuel rod surface. is the surface of the fuel rod adequately cooled?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Do you know the correct answer?

Acylindrical fuel rod (k 5 30 w/m∙k) of 2 cm in diameter is encased in a concentric tube and cooled...