Engineering, 23.10.2019 23:00, saraaaaaaaa20

Hot combustion gases of a furnace are flowing througha concrete chimney (k =1.4 w/m · °c) of rectangular cross section. the flow section of the chimney is 20 cm ×40 cm, and the thickness of the wall is 10 cm. the average temperatureof the hot gases in the chimney is ti=280°c, and the averageconvection heat transfer coefficient inside the chimney is hi=75 w/m2· °c. the chimney is losing heat from its outer surfaceto the ambient air at to=15°c by convection with a

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Do you know the correct answer?

Hot combustion gases of a furnace are flowing througha concrete chimney (k =1.4 w/m · °c) of rectang...