Engineering
Engineering, 23.10.2019 04:00, deonharris18

The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3.90 ω. the two batteries each have a voltage of 3.00 v. a circuit consists of three vertical wires connected at the top and bottom to each other. the left wire contains a resistor labeled r_3. the center wire contains a resistor labeled r_2. the right wire starts at the bottom with a battery labeled emf 2 with its negative pole pointing towards the top, which is then connected to a resistor labeled r_1 which is then connected to the positive pole of a battery labeled emf 1. the negative pole is then connected to the top connection point of the three wires. (a) find the current in through r3. a (b) how much power do the batteries deliver

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, namira16
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
image
Engineering, 04.07.2019 18:20, luisgonz5050
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
image
Engineering, 04.07.2019 18:20, annette211pdd8v9
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Do you know the correct answer?
The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3....

Questions in other subjects:

Konu
Mathematics, 14.04.2021 20:20
Konu
Social Studies, 14.04.2021 20:20
Konu
History, 14.04.2021 20:20