Engineering
Engineering, 22.10.2019 23:00, villafana36

In using a temperature probe, the following uncertainties were determined: hysteresis +/- 0.20° c linearization error +/- 0.3% of the reading repeatability +/- 0.05° c resolution error +/- 0.05° c zero offset +/- 0.5° c a) 0.057° c b) 0.696° c c) 0.541° c d) 0.071° c e) 0.819° c f) 0.692° c calculate the total bias error for a reading of 145° c. assume that the random errors have been determined with samples> 30. choose the most correct answer ( select the most correct from a through f ) calculate the total precision error for a reading of 145° c. assume that the random errors have been determined with samples> 30. choose the most correct answer ( select the most correct from a through f ) calculate the total uncertainty due to these effects for a reading of 145° c. assume that the random errors have been determined with samples> 30. choose the most correct answer ( select the most correct from a through f )

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, abdirahmansoloman
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
image
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
image
Engineering, 06.07.2019 03:20, loveuncondition
Not a characteristic property of ceramic material (a) high temperature stability (b) high mechanical strength (c) low elongation (d) low hardness
Answers: 2
Do you know the correct answer?
In using a temperature probe, the following uncertainties were determined: hysteresis +/- 0.20° c l...

Questions in other subjects:

Konu
Business, 21.01.2021 23:40
Konu
Mathematics, 21.01.2021 23:40
Konu
Computers and Technology, 21.01.2021 23:40