Engineering, 19.10.2019 01:00, ozzy1146

Alogic circuit realizing the function f has four inputs a, b, c, d. the three inputs a, b, and c are the binary representation of the digits 0 through 7 with a being the most significant bit. the input d is an odd-parity bit; that is, the value of d is such that a, b, c, and d always contains an odd number of 1’s. (for example, the digit 1 is represented by abc = 001 and d = 0, and the digit 3 is represented by abcd = 0111.) the function f has value 1 if the input digit is a prime number. (a number is prime if it is divisible only by itself and 1; 1 is considered to be prime, and 0 is not.)
draw a karnaugh map for f

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Do you know the correct answer?

Alogic circuit realizing the function f has four inputs a, b, c, d. the three inputs a, b, and c are...