Engineering, 18.10.2019 19:20, jaxondbagley
Consider a regenerative steam rankine cycle with a single open feedwater heater. at the entrance to the turbine the steam is at 17.5 mpa and 650°c. 20% of the steam is extracted from the turbine at 1.4 mpa and directed to the open feedwater heater directly, while the remaining steam is further expanded to 20 kpa before being sent to the condenser unit. the steam is condensed at 20 kpa to saturated liquid conditions before being pumped to higher pressure and directed to the open feedwater heater. after mixing in the open feedwater heater, the combined stream is pumped to high pressure and directed to the boiler to vaporize the steam.
(a) what is the degree of sub-cooling of the liquid at the exit to the open feedwater heater (i. e. what is the temperature difference between the liquid leaving the open feedwater heater and a saturated liquid at the same pressure)?
(b) what is the total work output from the turbine (report per unit mass flowing through the boiler)?
(c) what is the overall thermal efficiency?
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 19:10, rhiannpelham60
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
Do you know the correct answer?
Consider a regenerative steam rankine cycle with a single open feedwater heater. at the entrance to...
Questions in other subjects:
Chemistry, 21.07.2019 08:00
Biology, 21.07.2019 08:00
Mathematics, 21.07.2019 08:00
History, 21.07.2019 08:00
