Engineering, 17.10.2019 05:30, heynow111

Water initially at 200 kpa and 3008c is contained in a piston-cylinder device fitted with stops. the water is allowed to cool at constant pressure until it exists as a saturated vapor and the piston rests on the stops. then the water continues to cool until the pressure is 100 kpa. on the t-v diagrams sketch, with respect to the saturation lines, the process curves passing through both the initial, intermediate, and final states of the water. label the t, p and v values for end states on the process curves. find the overall change in internal energy between the initial and final states per unit mass of wate

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:20, samantha636

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

continue

Engineering, 04.07.2019 19:20, rida10309

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

continue

Engineering, 04.07.2019 19:20, amcd2002

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

continue

Do you know the correct answer?

Water initially at 200 kpa and 3008c is contained in a piston-cylinder device fitted with stops. the...