Engineering
Engineering, 17.10.2019 06:00, anna8352

Aparallel plate capacitor has an air filled gap. it is attached an emf and charged it to charge qo and voltage difference δvco. two different experiments are done. case a: the capacitor is disconnected from the emf first before the gap in between the plates is then filled with teflon. case b: the gap between the capacitor plates is then filled with teflon with the capacitor still connected directly across the terminals of the emf. which statement is true after the teflon is inserted into the gap? a. in case a, δvc is unchanged but q decreases to keep the net e field between the plates unchanged. in case b, q is unchanged but δvc increases due to a larger net e field between the plates. b. in case a, q is unchanged but δvc increases due to a larger net e field between the plates. in case b, δvc is unchanged but q decreases to keep the net e field between the plates unchanged. c. in case a, δvc is unchanged but q increases to keep the net e field between the plates unchanged. in case b, q is unchanged but δvc decreases due to a smaller net e field between the plates. d. in case a, q is unchanged but δvc decreases due to a smaller net e field between the plates. in case b, δvc is unchanged but q increases to keep the net e field between the plates unchanged.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
image
Engineering, 04.07.2019 19:10, kelseiroll9759
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
image
Engineering, 06.07.2019 04:10, johnbobjones
Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump
Answers: 1
Do you know the correct answer?
Aparallel plate capacitor has an air filled gap. it is attached an emf and charged it to charge qo a...

Questions in other subjects:

Konu
Mathematics, 22.02.2021 15:50