Engineering, 15.10.2019 05:00, darkdestroyer0888

Acartridge electrical heater is shaped as a cylinder of length l=200mm and outer diameter d=20 mm. under normal operating conditions the heater dissipates 2kw while submerged in a water flow that is 20℃ and provides a convection heat transfer coefficient of ℎ = 5000 w/m2k. neglecting heat transfer from the ends of the heater, determine its surface temperature . if the water flow is in advertently terminated while the heater continues to operate, the heater surface is exposed to air that is also at 20℃ but for which ℎ = 50 w/m2k. what is the corresponding surface temperature?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, yasyyas646646

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Do you know the correct answer?

Acartridge electrical heater is shaped as a cylinder of length l=200mm and outer diameter d=20 mm. u...