Engineering, 12.10.2019 23:30, dee3874

Ididn't understand the following matrix manipulation, as shown in the attached photo. how was it done?

Ididn't understand the following matrix manipulation, as shown in the attached photo. how was it don

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Do you know the correct answer?

Ididn't understand the following matrix manipulation, as shown in the attached photo. how was it don...