Engineering, 10.10.2019 03:30, eila3601

From experiments performed in water at 1.00 atm, 25°c, with ca0 = c b0 = 2.0 m, the rate is found to vary with fractional molar conversion of a (f_a) according to: 1/(-r(f_a ) )=0.33-1.27f_a-5.37f_a^2 [=] (l•hr)/mol calculate the time (hr) required to obtain 0.60 fractional molar conversion in a batch reactor containing 1,000 l of solution in which the initial concentration of each species is 2.0 m, and p and t are held constant at 1.0 atm and 25°c, respectively. calculate the volumetric flow rate (l/hr) of a stream containing 2.0 m of each reactant that is converted using a 1,000 l pfr to a fraction molar conversion of 0.60. calculate the volumetric flow rate (l/hr) of a stream containing 2.0 m of each reactant that is converted using a 1,000 l cstr to a fractional molar conversion of 0.60.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 19:20, nikkiebartels

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?

Answers: 2

continue

Engineering, 06.07.2019 02:30, onlymyworld27

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

continue

Engineering, 06.07.2019 02:30, josediaz1124

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

continue

Do you know the correct answer?

From experiments performed in water at 1.00 atm, 25°c, with ca0 = c b0 = 2.0 m, the rate is found to...