Engineering, 09.10.2019 02:30, sbelgirl2000

3. (a) (5 points) suppose n packets arrive simultaneously to a link at which no packets are currently being transmitted or queued. each packet is of length l and the link has transmission rate r. what is the average queuing delay for the n packets? (b) (5 points) now suppose that one of such n packets arrives to the link every l/2r seconds. what is the average queuing delay of a packet?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 19:10, thawkins79

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

continue

Engineering, 06.07.2019 03:10, liliauedt

Explain the strain-hardening phenomenon on the basis of dislocation - dislocation strain field interactions. also, briefly describe what generally happens to the ductility of a metal that has been strain hardened (i. e. does strain hardening make a metal more ductile or

Answers: 3

continue

Engineering, 06.07.2019 04:20, smokemicpot

Assume that you are asked to perform a boring operation on a large-diameter hollow workpiece. would you use a horizontal or a vertical boring mill?

Answers: 3

continue

Do you know the correct answer?

3. (a) (5 points) suppose n packets arrive simultaneously to a link at which no packets are currentl...