Engineering, 08.10.2019 00:30, amandasantiago2001

The waveform generator on the lab bench assumes a low load impedance (resistance) for its output (50 ohms). when a high impedance (resistance) load, such as ours, is attached, the waveform generator will incorrectly report the amplitude of its output as one-half of what it really is. from the hp (agilent) 33120a manual, describe below how to change the settings of the waveform generator to report output amplitude correctly into high impedance loads. (hint: see page number 40 of 33120a manual). note that when the waveform generator is turned off and back on, the output impedance setting is restored to the low load impedance and must be changed again. remember this for this lab and future labs!

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Engineering, 04.07.2019 19:20, zoebtharpe

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

continue

Do you know the correct answer?

The waveform generator on the lab bench assumes a low load impedance (resistance) for its output (50...