Engineering
Engineering, 07.10.2019 17:30, nadine3782

You are on a planetary colonizing expedition. your mission objective is to get the water balloon eggs to the surface of the planet without rupturing. however the engineers on earth had used improper force units and you discover that the rocket does not have enough fuel to land on the planet without crashing. your only option is to drop the water balloon eggs from the distance of the planetary orbit of your rocket ships. the gravity on the planet is such that a drop from your orbital distance is similar to a 12 meter drop on earth. you must use only the material on your rocket ship and build 10 to 12 protective devices. to be viable, half of your water balloon eggs must survive the fall or you would have failed in your mission. also of the half that survive, half must be female (red or yellow balloons) and half must be male (green or blue balloons). since you are not sure of the atmospheric conditions of the planet, you do not know for sure a parachute will work. from the 10 to 12 different devices, you decide that 1/3rd should be a parachute design, 1/3rd should be a cushion only device, and 1/3rd should be a combination of a drag and cushion design.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Do you know the correct answer?
You are on a planetary colonizing expedition. your mission objective is to get the water balloon egg...

Questions in other subjects:

Konu
Mathematics, 01.07.2021 22:40