![Engineering](/tpl/images/cats/User.png)
Engineering, 07.10.2019 18:00, gunnatvinson
Consider a regenerative vapor power cycle with two feedwater heaters, a closed one and an open one, and reheat. steam enters the first turbine stage at 12 mpa, 640°c, and expands to 2 mpa. some steam is extracted at 2 mpa and fed to the closed feedwater heater. the remainder is reheated at 2 mpa to 600°c and then expands through the second-stage turbine to 0.3 mpa, where an additional amount is extracted and fed into the open feedwater heater operating at 0.3 mpa. the steam expanding through the third-stage turbine exits at the condenser pressure of 60 kpa. feedwater leaves the closed heater at 210°c, 12 mpa, and condensate exiting as saturated liquid at 2 mpa is trapped into the open feedwater heater. saturated liquid at 0.3 mpa leaves the open feedwater heater. each turbine stage and the pumps have an isentropic efficiency of 80%. determine for the cycle: (a) the heat transfer to the working fluid passing through the steam generator, in kj per kg of steam entering the first-stage turbine. (b) the percent thermal efficiency. (c) the heat transfer from the working fluid passing through the condenser to the cooling water, in kj per kg of steam entering the first-stage turbine.
![answer](/tpl/images/cats/otvet.png)
Answers: 1
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Do you know the correct answer?
Consider a regenerative vapor power cycle with two feedwater heaters, a closed one and an open one,...
Questions in other subjects:
![Konu](/tpl/images/cats/mir.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/biologiya.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 20.07.2020 21:01
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/biologiya.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/health.png)
Health, 20.07.2020 21:01