Engineering
Engineering, 06.10.2019 20:10, granthazenp5e9mj

Water is being pumped from bottom of a well 15ft deep at the rate of 200gal/he into a vented storage tank to maintain a level of water in a tank 165ft above the ground. to prevent freezing in the winter a small heater put 3btu/hr into the water during its transfer from the well to the storage tank, assuming that the well water is at 35fahrenhiet? a 2-horsepower pump is being used to pump the water . about 55% of the rated horsepower goes into work of pumping and the rest is dissipated as heat to the atomsphere.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:20, samueltaye
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
image
Engineering, 04.07.2019 18:20, annette211pdd8v9
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
Do you know the correct answer?
Water is being pumped from bottom of a well 15ft deep at the rate of 200gal/he into a vented storage...

Questions in other subjects:

Konu
Mathematics, 18.11.2020 01:20
Konu
Mathematics, 18.11.2020 01:20