Engineering
Engineering, 04.10.2019 21:20, hrcatena

You wish to buy a new freezer for your basement. the primary use of the freezer will be to prepare ice for family parties. you have a very large family, with grandparents, parents, sisters, brothers, uncles, aunts, cousins, nephews, nieces, and grandchildren. as a result, family birthday parties are held every couple of weeks, and you need lots of ice for drinks. you want the freezer to convert 10.2 kg of water at 21.5°c to 10.2 kg of ice at −9.2°c in 2.00 h. but, in order to keep your electric bill down, you want the power rating of the freezer to stay below 100 w. from these requirements, you determine the minimum cop of the freezer that will satisfy your needs. (consider that the specific heat of water is 4,186 j/(kg · °c), the specific heat of ice is 2,090 j/(kg · °c), the latent heat of fusion of water is 3.33 ✕ 105 j/kg, and the latent heat of vaporization of water is 2.26 ✕ 106 j/kg.)

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
image
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Do you know the correct answer?
You wish to buy a new freezer for your basement. the primary use of the freezer will be to prepare i...

Questions in other subjects:

Konu
Biology, 23.10.2020 20:40
Konu
Business, 23.10.2020 20:40