Engineering, 05.10.2019 10:30, gomez1718

Ayacht of charactersitic length 35.82 m is being designed. the density and absolute viscosity of the water from the ocean where it would be used is 1022.8 kg/m^3 and 0.00106 pa. s respectively. the froude number associated with this concept yacht at its cruising speed is 0.71. if the 0.185 scaled down version of a yacht has to be tested in a towing tank which has a fluid of density of 980 kg/m"". what should be the absolute viscosity (rounded of to 6 decimal places) of the fluid in the towing tank to obtain a dimensionally similar flow condition. also calculate the cruising speed for the original yacht and give the answer in knots. viscosity of the fluid in the towing tank = cruising speed of the yacht =

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Do you know the correct answer?

Ayacht of charactersitic length 35.82 m is being designed. the density and absolute viscosity of the...