Engineering, 03.10.2019 01:00, Sl33pyGrl

An inclined venturi meter is used to measure the flowrate of water through a pipe having a diameter of 5.4 cm. the pipe is inclined 40 degrees to the horizontal. the distance between the entry section and the throat of the venturi along its longitudinal axis is equal to 12 cm. the throat diameter is 1.8cm. the reading in the u-tube manometer is equal to 17cm. an electronic flowrate sensor installed further upstream along the pipe shows a reading equal to 96 dm3/min. the relative density of the manometric fluid is 13.6. calculate the: (i) theoretical flowrate as derived from the u-tube reading. (ii) discharge coefficient of the venture meter.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

Do you know the correct answer?

An inclined venturi meter is used to measure the flowrate of water through a pipe having a diameter...