Engineering, 02.10.2019 03:00, cecem58

Aspecimen of steel having an initial diameter of 0.503 in was tested in tension using a gauge length of 2 in. the following data were obtained for the elastic and plastic states. elastic stateload elongation1000 0.00042000 0.00063000 0.00104000 0.00137000 0.0023plastic stateload elongation8800 0.19849200 0.19879100 0.196313200 0.192415200 0.1875estimate the value of the modulus of toughness, assuming that the last data point corresponds to fracture

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 19:10, shayshay7874

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

continue

Do you know the correct answer?

Aspecimen of steel having an initial diameter of 0.503 in was tested in tension using a gauge length...