Therr workers trying to move a 1x1x1.2-m crate apply to the
cratethe three horizontal fo...
Engineering, 02.10.2019 00:00, angie249
Therr workers trying to move a 1x1x1.2-m crate apply to the
cratethe three horizontal forces shown. (a) if p=240 n, replace the
threeforces with an equivalent force-couple system at a. (b)
replace theforce-couple system of part a with a single force, and
determinewhere it should be applied to side ab. (c) determine the
magnitudeof p so that the three forces can be
replaced witha single equivalent force applied at b.
Answers: 1
Engineering, 04.07.2019 19:10, nida7864
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Engineering, 04.07.2019 19:20, natalie2sheffield
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
Engineering, 06.07.2019 03:10, tyheath42
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k, p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
SAT, 26.11.2021 01:00
Mathematics, 26.11.2021 01:00
Mathematics, 26.11.2021 01:00
Computers and Technology, 26.11.2021 01:00
Mathematics, 26.11.2021 01:00