Engineering
Engineering, 29.09.2019 00:30, bossboybaker

Atomato can be idealized as a cnhere lealized as a sphere with internal heat generation that is due to ripening. consider a tomato with a diameter of 80 mm, density of 840 kg/m? , thermal conductivity of 0.5 w/(mk), uniform internal heat generation of 4000 j/(kg*day), and a film coefficient of 7.5 w/(m²k). if the tomato is wrapped in 5 mm of urethane foam, k=0.026 w/(mk), estimate the steady state temperature at the center of the sphere with a surrounding air temperature of 2°c.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
image
Engineering, 04.07.2019 18:20, maciemarklin79981
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Do you know the correct answer?
Atomato can be idealized as a cnhere lealized as a sphere with internal heat generation that is due...

Questions in other subjects:

Konu
Mathematics, 03.02.2020 13:44
Konu
Mathematics, 03.02.2020 13:44
Konu
Mathematics, 03.02.2020 13:44
Konu
Mathematics, 03.02.2020 13:44