Engineering, 26.09.2019 16:10, Day1201

The flow is turned using a compression ramp and an expansion corner. if the approach flow mach number is, m=3, approach flow static pressure is, p1=1 atm, and the ramp angle is 10 degrees, a) (10 pts) calculate the mach number after the compression ramp. b) (10 pts) calculate the flow turning angle, t, required to achieve m=3 after the expansion corner. c) (10 pts) calculate the total pressure after the compression corner. d) (10 pts) calculate the static pressure after the expansion corner.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Do you know the correct answer?

The flow is turned using a compression ramp and an expansion corner. if the approach flow mach numbe...